Page 237 - 87-BOOK3

LOT 3428
RPB/MAC M10 SMG/Silencer Class III/NFA
-A) RPB/MAC M10 Submachine Gun, Class III/NFA Fully Transferable, with Accessories -
Serial no. C456, 45 ACP cal., 6 inch round bbl., matte black finish, metal stock. Post front and fixed
peep rear sights, with a threaded muzzle, bolt-locking rotating cocking knob, manual safety on the right side,
selector switch on the left, swiveling web front grip and telescoping buttstock. The MAC Powder Springs
address is present on the right side of the frame, with the RPB Atlanta address on the left. With two extra magazines, a
barrel extension, and a styrofoam carton.
CONDITION: Excellent, with 97% of the original matte black phosphate finish, showing light handling marks, a small amount
of spotting, and a few areas of brown patina. Similar wear is present on the stock. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
B) RBP Industries M10 Class III/NFA Silencer - Serial no. T578, 9 mm , black finish. Designed to use a combination of ported expansion chambers and wipes for sound moderation, with an overall length of 11 1/2 inches and insulating foam cover
over the front tube section.
LOT 3429
RPB/MAC M11 SMG/Silencer, Class III/NFA
-A) RPB/MAC M11, 9mm Parabellum Conversion, Class III/NFA Fully Transferable Submachine Gun, with Accessories - Serial no. A1410, 9 mm cal., 5 inch round bbl., matte gray phosphate finish. Originally manufactured in 380 ACP (aka 9mm Kurz) configuration, this example has been altered to chamber 9mm Parabellum, with the magazine well extended to accept a modified High Power magazine, chamber altered, bolt shortened, heavier buffer installed and the original “9mm K” caliber stamp on the receiver altered to read “9mm P”. While no documents were supplied with the lot to say who did the work, an included copy of the August 1982 issue of “Eagle” magazine has an article featuring the “Maxi Mac” M11 conversion executed by Tim J. Kader (dba TJK
of Elyria, Ohio), with the included pictures closely matching the alterations on this SMG. Blade front and peep rear sights, with a threaded muzzle, swiveling base for a front web grip (not included), “S.O.F.” on the front of the upper receiver, selector switch on the right, safety on the left, and a two-position telescoping buttstock. Three magazines (aftermarket High Power mags professionally altered for compatibility with the M11 mag catch) are included, as is a styrofoam carton and the aforementioned publication. CONDITION: Very fine, with 90% of the original matte phosphate finish, showing areas of brown patina, bright edge wear and mild handling marks. The grip is damaged, with pieces absent, currently secured with tape. Action
is stiff, but in fine order. NOTE: This weapon
is a National Firearms Act (NFA), fully
transferable Class 3, which is registered
with the Bureau of Alcohol, Tobacco,
Firearms and Explosives, (BATFE) under the
provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
B) RBP Industries M10 Class III/NFA Silencer - Serial no. T581, 9 mm , black finish. Designed to use a combination of ported expansion chambers and wipes for sound moderation, with an overall length of 11 1/2 inches and insulating foam cover over the tube sections. A short thread adapter (male side compatible with the silencer,
female side compatible with gun A’s muzzle) is included.
CONDITION: Fine overall. A few spots of rust and some mild handling marks are present on the tube sections, and the covers show scuffing and tears. Some oxidization/residue is present on the wipes, which appear little fired. NOTE: This Silencer is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms
and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
Estimate: 7,500 - 11,000
LOT 3430
Military Armament Corporation M10A1 Submachine Gun, Class III/NFA Fully Transferable Machine
Gun, with Accessories - Serial no. B2045, 9 mm cal., 6 inch round bbl., matte finish. One of the signature weapons
of the 20th century, the Ingram M10 (also known as the MAC-10) was sought out by military and paramilitary operators as a potent and concealable close-quarters weapon, in addition to a multitude of appearances in film and television. This particular M10A1 is addressed to Marietta, Georgia. Fixed sights, threaded barrel for a suppressor (not included), safety switch on the lower right of the receiver, selector lever on the left, and three-line address markings below the ejector port. With a black plastic grip extension and a telescoping two-position wire buttstock. Included with the lot is a barrel extension/faux silencer, a short threading adapter, loading tool and an Ingram-branded carton
CONDITION: Very fine, with some spotting
and handling marks on the tube and
some tearing and material loss on the cover. The
wipes are intact, but show erosion and residue buildup.
Not physically compatible with the RPB/MAC M10 also included in this lot. NOTE: This Silencer is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478. Estimate: 8,000 - 12,000
CONDITION: Excellent, with 97% plus original matte finish, showing mild wear and spotting overall. The barrel extension shows a number of scuffs and patches of spotting. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
Estimate: 7,000 - 10,000
235