Page 312 - 86-Book1

LOT 358
Group Industries/IMI UZI Submachine Gun, Class III/NFA Fully Transferable Machine Gun - Serial no. 000631, 9 mm cal., 10 inch round bbl., matte black finish, metal stock. Originally manufactured by IMI and imported by Action Arms as a
semi-automatic UZI carbine, this weapon has been converted to full
automatic and registered by Group Industries of Louisville, Kentucky as
a dual caliber (9mm and 45) machine gun. To perform this conversion, the markings
were altered to the “SMG UZI” designation, the bolt restrictor block removed from the receiver,
and a ratchet-equipped top cover, full automatic bolt and trigger set installed; the barrel restrictor collar is still installed.
Adjustable post front and peep rear sights, with the altered IMI/Action Arms marks on the sides of the receiver, Group’s logo
on the underside, and modified “A R S” selector markings on the trigger housing. Fitted with a bayonet lug, folding stock,
and ribbed pistol grip. Included with the lot is a canvas soft case, 12 extra magazines, a velcro-backed nine-cell magazine pouch, and a DeSantis shoulder holster rig (hip support absent).
CONDITION: Very fine as converted to full auto by Group Industries, with 95% of the matte black finish, showing mild wear and handling marks overall. The grip is excellent, with some minor scratches. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
Estimate: 9,500 - 16,000
LOT 359
Military Armament Corporation
M10 Submachine Gun with a
SWD M10 Silencer, Class III/NFA
-A) MAC M10 Submachine Gun,
Class III/NFA Fully Transferable
Machine Gun - Serial no. 1-3003742,
45 ACP cal., 6 inch round bbl., matte black finish, metal stock, plastic grips. One of the signature weapons
of the 20th century, the Ingram M10 (also known as the MAC-10) was sought out by military and paramilitary operators
as a potent and concealable close-quarters weapon, in addition to a multitude of appearances in film and television. This
particular M10 is addressed to Powder Springs, Georgia. Fixed sights, threaded barrel for a suppressor (see B), safety switch on
the lower right of the receiver, selector lever on the left, and three-line address markings below the ejector port. With a black plastic grip extension, telescoping two-position wire buttstock and a green nylon web foregrip. Magazine absent.
CONDITION: Excellent, with 95% plus original matte phosphate finish, showing a number of light rubs, scratches and handling marks.
The stock and grip panel are in equal condition. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully
transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478. B) RBP Industries M10 Class III/NFA Silencer - Serial no. S312, 45 , black finish. Designed to use a combination of baffles and wipes for sound moderation, with an overall length of 11 3/8 inches and a padded black rubber insulating cover.
CONDITION: Excellent, with minor handling marks overall. The internal edges of the wipes are a bit ragged, but the wipes still look and feel solid. NOTE: This Silencer is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
Provenance: The Al Walker Collection.
Estimate: 9,000 - 13,000
LOT 360
SWD M11/Nine
Submachine Gun
with Silencer and
Accessories, Class III/
NFA -A) SWD M11/Nine, Class III/NFA Fully Transferable Machine Gun with Extra Magazines
and Interchangeable Upper Receivers - Serial no. 86-0007351, 9 mm cal., 5 1/2 inch round bbl., matte
black finish, metal stock. A descendant of Ingram’s M10, the M11/Nine is made with a slightly longer receiver than the
M11 to accommodate a caliber upgrade from 380 ACP to 9mm Parabellum and allow for a longer range of bolt travel to dampen felt recoil. Fixed blade and peep sights, with the “SEMI/SMG” selector switch on the left side of the frame, safety switch next to the trigger guard and standard markings on the right side of the frame. A swiveling nylon strap is installed on the barrel behind the threading, with a contoured grip with the Cobray logo on the back and a collapsing wire stock. Included with the item are 6 extra magazines, a 4-magazine pouch, shipping box, small spare parts, loading tools, two threaded “faux silencer” barrel extensions and a soft case.
CONDITION: Excellent, with 97% of the original phosphate matte finish, showing one bright spot on top of the receiver, mild
wear and handling marks overall. The nylon strap is a non-factory replacement, and the stock is in good working order. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478. B) AWC Systems Technologies Mk9 Silencer, Class III/NFA Silencer - Serial no. G-241, 9 mm , matte black finish. Threaded for compatibility with the M11/Nine, but using a more modern baffle assembly with no wipes. Overall length is 12 1/2 inches. With a lightly insulated canvas cover.
CONDITION: Some tool marks are present on the endcap, otherwise the silencer is excellent. The cover is also excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.
310 Estimate: 7,500 - 11,000