Page 229 - 88-BOOK3

LOT 3390
LOT 3389
Desirable Group Industries HR4332 Class III/NFA Fully Transferable Submachine Gun, with Accessories - Serial no. 101654, 9 mm cal., 10 inch round bbl., matte black finish, synthetic stock. Manufactured in the USA in direct emulation of the original IMI Uzi submachine gun, the HR 4332 was among the final generation of fully transferable American machine guns, manufactured shortly before the Firearm Owners Protection Act (aka House Resolution 4332) went into effect making it among the last fully transferable machine guns
manufactured in the United States. The receiver is properly without the barrel ring and bolt restrictor block that would normally prevent installation of military configuration components, and the item is currently fitted with a military- contour SMG barrel, a smooth-sided bolt, an unmarked receiver cover with ratcheting cocking handle, and a full auto trigger group with “A R S” markings. The left side of the receiver bears both Group Industries and Vector Arms marking. Fitted with a dual set of ribbed plastic pistol grips, a fixed plastic buttstock, and a canvas sling. Included with the lot is a bonanza grouping of accessories; a 22 LR conversion unit with multiple magazines, ninety (90) extra 9mm magazines, two 9mm drum magazines, and small tools. CONDITION: Excellent, with 90% plus original matte black finish, showing bolt retraction wear and handling marks overall. The grip screws are replacements, otherwise the furniture is very fine, with mild scuffs and scratches. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478. Estimate: 11,000 - 16,000
Military Armament Corporation/SWD M10 Submachine
Gun and Silencer Set, Class III/NFA -A) MAC M10, Class III/
NFA Fully Transferable Machine Gun, with Accessories - Serial
no. 1-3002530, 45 ACP cal., 5 3/4 inch round bbl., matte phosphate finish, metal stock, plastic grips. One of the signature
weapons of the 20th century, the Ingram M10 (also known as the MAC-10) was sought out by military and paramilitary
operators as a potent and concealable close-quarters weapon, in addition to a multitude of appearances in film and television.
This particular M10 is addressed to Powder Springs, Georgia. Fixed sights, threaded barrel for a suppressor (see B), safety switch on the lower right of the receiver, selector lever on the left, and three-line address markings below the ejector port. With a black plastic grip extension, telescoping two-position wire buttstock and a nylon web fore grip. Includes a Cobray canvas soft case, two extra magazines, loading tool, sling, manual, and an aftermarket buttstock.
CONDITION: Excellent, with 98% of the original matte gray phosphate finish, showing some light handling marks and edge wear overall. Small patches of rust are visible on the magazines. Mechanically excellent. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478. B) RBP Industries M10 Class III/NFA Silencer - Serial no. S62, 45 , black finish. Designed to use a combination of a ported expansion chamber and wipes for sound moderation, with an overall length of 11 1/4 inches and a padded black canvas insulating cover.
CONDITION: Excellent, with mild exterior wear. The wipes have been blown out, with a few traces
of crystallized material remaining in the endcap. NOTE:
This Silencer is a National Firearms Act (NFA), fully
transferable Class 3, which is registered with the
Bureau of Alcohol, Tobacco, Firearms and Explosives,
(BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27
CFR part 478.
Estimate: 9,500 - 14,000
LOT 3391
RPB/Military Armament Corporation M10-A1 Submachine Gun, Class III/NFA Fully Transferable Machine Gun, with Accessories - Serial no. B1922, 9 mm cal., 6 inch round bbl., black phosphate finish, metal stock. One of the signature weapons of the 20th century, the Ingram M10 (also known as the MAC-10) was sought out by military and paramilitary operators as a potent and concealable close-quarters weapon, in addition to a multitude of appearances in film and television. The M10A1 includes minor design changes to accommodate the use of 9mm NATO ammunition. Fixed sights, with the MAC (Marietta, Georgia) markings on the right side, RPB (Atlanta, Georgia) markings on the left, a two position “SEMI”/”FULL” selector on the left, and a safety switch on the underside near the trigger. Fitted with
a plastic back strap extension and a two-position telescoping steel stock. Included with the lot is a generic plastic case, eight extra magazines (plus four incompatible Uzi magazines), loading tool, brass catcher, nylon straps, thread protector and four “faux silencer” barrel extensions.
CONDITION: Very fine, with 85% of the refinished black phosphate finish overall, with pitting visible beneath the finish on the lower receiver, mild polishing marks, and some edge wear and scuffing. The accessories are fine overall, some showing mild wear/oxidization. Mechanically very good. NOTE: This weapon is a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) under the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478. Estimate: 5,500 - 8,500
227